Aldila
Workshop guide · Aldila
How to trim Aldila shafts
Aldila lists the standard tip trim values on the product page of each shaft. Many models in our shop such as NV, Tour Green, Quaranta or RIP are no longer listed there. That is why the trim code in our product description applies.
All values in inches (1 inch = 25.4 mm), tip trim at the tip end. Then cut at the butt end to playing length.
Good to know
- The trim code in the product description is what counts. You will find the values in our trim sheet.
- The special code W23 C applies to some Aldila wood shafts: no tip trim, 1 inch for fairway woods.
- Aldila advises against trimming shafts again that were already installed and pulled.
- Cut taper tip hybrid shafts such as RIP 85 Taper at the butt end only.
Source: Aldila Education FAQ (aldila.com), as of November 2026. Manufacturer figures are recommendations, fine-tuning belongs in a fitting.
FAQ: trimming Aldila shafts
Where do I find the trim values for my Aldila shaft?
Via the trim code in the product description and our trim sheet.
Can I re-trim a used Aldila shaft?
Aldila does not recommend it. We are happy to check it in our workshop.
Do I tip trim an Aldila driver shaft?
That depends on the trim code. You will find the driver value in the trim sheet.
Rather have it trimmed?
We cut, install and check your shaft in our workshop in Erfurt, Germany.