Skip to main content Skip to search Skip to navigation

Workshop guide · True Temper

How to trim True Temper shafts

True Temper recommends a simple progression for parallel tip iron shafts such as Dynamic Gold: from the 4-iron, 1/2 inch more at the tip per iron. Taper tip shafts are never tip trimmed.

Parallel tip iron shafts (e.g. Dynamic Gold .370)

Shaft 2-iron 3-iron 4-iron 5-iron 6-iron 7-iron 8-iron 9-iron Wedge
Tip trim 0" 0" 1/2" 1" 1 1/2" 2" 2 1/2" 3" 3 1/2"

All values in inches (1 inch = 25.4 mm), tip trim at the tip end. Then cut at the butt end to playing length.

Good to know

  • Trim the tip first, then cut at the butt end to final length.
  • Taper tip shafts (.355, for example XP95 Tapered, Dynalite Gold XP Tapered) are built for fixed lengths: cut at the butt end only.
  • The long irons stay untrimmed at the tip. That gives a little more launch there.
  • Tip trimming stiffens the tip: less launch and spin, tighter dispersion. Too much feels harsh.

Source: True Temper Trim Instruction Guide (truetemper.com), as of November 2026. Manufacturer figures are recommendations, fine-tuning belongs in a fitting.

To the trim sheet with all trim codes →

FAQ: trimming True Temper shafts

How much do I tip trim a Dynamic Gold for the 7-iron?

The parallel tip version (.370) 2 inches at the tip according to True Temper, then cut at the butt end to playing length.

Can I tip trim a Dynamic Gold Tapered?

No. Taper tip shafts are made per iron and are cut at the butt end only.

Does this also apply to Project X and Grafalloy?

Both brands belong to True Temper today. For Project X, True Temper gives its own values for woods, see the Project X brand page.

Rather have it trimmed?

We cut, install and check your shaft in our workshop in Erfurt, Germany.

To the shaft service