Skip to main content Skip to search Skip to navigation

UST-Mamiya



Items 1 - 20 of 20

Workshop guide · UST Mamiya

How to trim UST Mamiya shafts

UST Mamiya does not publish a chart per club number. The manufacturer clearly advises against tip trimming driver shafts, though. On iron shafts, 1/2 to 1 inch of tip trim makes the tip noticeably stiffer.

All values in inches (1 inch = 25.4 mm), tip trim at the tip end. Then cut at the butt end to playing length.

Good to know

  • The trim code in the product description is what counts, for example W4 or IH16. You will find the values in our trim sheet.
  • Cut Recoil Tapered (.355) and other taper tip irons at the butt end only.
  • Driver (for example ProForce V2, Helium): no tip trim, cut to length at the butt end only.

Source: UST Mamiya FAQ (ustmamiya.com), as of November 2026. Manufacturer figures are recommendations, fine-tuning belongs in a fitting.

To the trim sheet with all trim codes →

FAQ: trimming UST Mamiya shafts

Can I make a UST Mamiya driver shaft stiffer by tip trimming?

UST Mamiya does not recommend it. Better choose the right flex.

How much do I tip trim a Recoil iron shaft?

Parallel tip by trim code in the trim sheet. Recoil Tapered at the butt end only.

Where is the trim code?

In the product description of every shaft in our shop.

Rather have it trimmed?

We cut, install and check your shaft in our workshop in Erfurt, Germany.

To the shaft service